關注商店
今日商品數 1416
評價分數 (11542)
留言版 (587)
瀏覽人次 (258901)
購買人次 (5982)
平均出貨天數 (1)
.商品所在地 台北市
訂閱商店EDM
看所有商品列表 »
看最新上架商品 »
711超商取貨付款 »
Raspberry Pi 5
自駕導航
人工智慧(AI)專區
ROS / 2.0
Nvidia
Raspberry Pi
Banana Pi
micro :bit
ESP32/8266
Arduino
感測器
通訊裝置
視覺/顯示/語音
開發 / 控制
PlayRobot
各式機器人
配件
工具
品牌
互動裝置
人機裝置
穿戴裝置
中國好東西_CGGs
LinkIt
LattePanda
雜誌書籍
Propeller八核心
商店介紹
購物說明
購物車
留言版 (587)
客服
回首頁
飆機器人電子商城
  ★商品流動速度太快,若有缺貨會盡快告知,也可主動詢問! ★營業時間:周一至周五9:00-17:00,快速聯繫可加飆機器人官方Line@:@playrobot。 ★部分商品進貨期較長,如需急用,請提前告知。
PChome > 商店街首頁 > 3C周邊 > 飆機器人電子商城 > 其他
 


〈商品編號:M36963638〉
獲得現金積點:4 (1點=1元) 說明
15天鑑賞期
給予買家商品15天鑑賞期,品鑑商品更充裕
退貨無負擔
黑貓宅急便到府收件退貨商品,退貨便利無運費
假一賠二
非真品承諾商品退款再賠償該商品金額
(詳見說明)
 

3.3V升壓/降壓型穩壓器(S9V11F3S5CMA)

S9V11F3S5CMA開關升壓/降壓調節器可高效地產生固定的3.3 V或5 V輸出,無論它是高於還是低於輸入電壓,範圍可以從2 V到16 V. :最小啟動電壓為3 V,但之後它的工作電壓為2 V.調節器還具有防止電池過度放電的帶滯後功能,可精確調節的低壓切斷。
一次付清特價 368
付款方式 
超商付款
取貨付款
運  費單店購物車滿 1000 元(含)以上免運費,未滿者自付運費
郵局 60
7-11取貨付款 60
7-11純取貨 60***
商品所在地 台北市
  
加入追蹤加入追蹤 留言版留言版(587)
分享到
 

產品簡介

The S9V11x family of efficient switching regulators (also called switched-mode power supplies (SMPS) or DC-to-DC converters) use a buck-boost topology to convert both higher and lower input voltages to a regulated output voltage. They take input voltages from 2 V to 16 V and increase or decrease them as necessary, offering a typical efficiency of over 85% and a typical output current of up to 1.5 A. The flexibility in input voltage offered by this family of regulators is especially well-suited for battery-powered applications in which the battery voltage begins above the regulated voltage and drops below as the battery discharges. Without the typical restriction on the battery voltage staying above the required voltage throughout its life, new battery packs and form factors can be considered.


文件下載

Dimension diagram for the Step-Up/Step-Down Voltage Regulator S9V11x (142k pdf)Note: this dimension diagram does not apply to the smaller S9V11F5.3D model of the Step-Up/Step-Down Voltage Regulator S9V11x (4MB step)Note: this model does not apply to the smaller S9V11F5.Drill guide for the Step-Up/Step-Down Voltage Regulator S9V11x (23k dxf)

This DXF drawing shows the locations of all of the board’s holes. Note that this does not apply to the smaller S9V11F5.


產品規格
Dimensions
Size: 0.5″ × 0.6″ × 0.25″1
Weight: 0.8 g1 General specifications
Minimum operating voltage: 2 V2
Maximum operating voltage: 16 V
Maximum output current: 1.5 A3
Output voltage: 3.3 V4
Reverse voltage protection?: N
Maximum quiescent current: 1 mA5
Low-voltage cutoff: adjustable
Identifying markings
PCB dev codes: reg20b
Other PCB markings: 0J10534

Notes:
Without included optional headers.
Note:
1.the minimum startup voltage is 3V, but the regulator can operate down to 2V after startup.
2.Under typical conditions, where the input voltage is close to the output voltage. Maximum output current can be higher when stepping down and lower when stepping up.
3.Output can be changed to 5 V by driving the SEL pin over 1.1 V.
With no load. Actual quiescent current depends on input voltage; it is typically under 300 µA when the input voltage is close to the output voltage.#XX#

    政策宣導

  • 為防治動物傳染病,境外動物或動物產品等應施檢疫物輸入我國,應符合動物檢疫規定,並依規定申請檢疫。擅自輸入屬禁止輸入之應施檢疫物者最高可處七年以下有期徒刑,得併科新臺幣三百萬元以下罰金。應施檢疫物之輸入人或代理人未依規定申請檢疫者,得處新臺幣五萬元以上一百萬元以下罰鍰,並得按次處罰。
  • 境外商品不得隨貨贈送應施檢疫物。
  • 收件人違反動物傳染病防治條例第三十四條第三項規定,未將郵遞寄送輸入之應施檢疫物送交輸出入動物檢疫機關銷燬者,處新臺幣三萬元以上十五萬元以下罰鍰。
詳情請見 飆機器人電子商城 購物說明
如對本產品有任何問題,請洽 飆機器人電子商城 客服中心